I want to make flags for *Oak & Iron* and for *Blood & Plunder*. ## Oak & Iron I need pennants and ensigns at 1/600 scale. These will be made of PVA-glue stiffened paper, with bends put into them. The ensigns will also need poles drilled in the stern. I want them to be swappable. I’ll need to affix the flags to the poles, and keep the poles-and-flags stored in a block of foam. The pennants should be country-independent and can stay? The ensign poles should be pretty thin. Will the pressure of the model around the hole keep the pin in, or will I need a separate stop to keep the flag pole from going too far? Or do I just make it long enough to hit the base? ## Blood & Plunder Big pennants and ensigns for 1/60 scale ships. I don’t think I’ve got or will have any standard bearers on land for a while. Same as above, really. But making the ensign pole not stick through will be a harder requirement, since B&P ships don’t have bases.